Optically active copolyamides by melt and solution condensation polymerization

The melt and solution condensation copolymerization of nylon salts which were prepared from d-camphoric acid and adipic acid with hexamethylenediamine were carried out, and optically active copolyamides were obtained. The copolyamides obtained had a positive specific rotation. The specific rotations for the copolyamides increased with increasing content of d-camphoryl units in the copolymers. The optical rotatory dispersion of the copolyamides had positive curves and were found to fit the simple Drude equation. The λ_c values of the polymers obtained by the melt and solution condensation polymerization were 241 mμ and 245 mμ, respectively.     

Influences of fatty acid moiety and esterification of polyglycerol fatty acid esters on the crystallization of palm mid fraction in oil-in-water emulsion

We examined the crystallization of palm mid fraction (PMF) in oil-in-water (O/W) emulsion, after adding polyglycerol fatty acid esters (PGFEs). We employed ultrasonic velocity measurements and DSC techniques, with special emphases on the influences of fatty acid moiety and esterification of PGFE. Twelve types of PGFEs were examined as additives. PGFEs have a large hydrophilic moiety composed of 10 glycerol molecules to which palmitic, stearic and behenic acids were esterified as the fatty acid moiety with different degrees of esterification. Crystallization temperature (T(c)) of PMF remarkably increased with increasing concentrations of the PGFEs as the chain length of the fatty acid moiety increased, and the PGFE became more hydrophobic in accordance with increasing degree of esterification. We observed that the heterogeneous nucleation of PMF in the O/W emulsion was activated at the oil-water interface, where the template effect of very hydrophobic long saturated fatty acid chains of the PGFE might play the main role of heterogeneous nucleation.     

Determination of nitrogen- and phosphorus-containing pesticide residues in vegetables by gas chromatography with nitrogen-phosphorus and flame photometric detection after gel permeation chromatography and a two-step minicolumn cleanup

An efficient and reliable multiresidue method for determining pesticide residues in a large number of vegetable samples was studied. First, the important target compounds for monitoring, 52 nitrogen- and/or phosphorus-containing pesticides, were selected. The sample was extracted with acetonitrile, and the separated acetonitrile layer was cleaned up by a salting-out step. The acetonitrile extract was purified by gel permeation chromatography that divided the pesticide eluate into 2 fractions; the pesticide fractions were respectively purified by a 2-step minicolumn cleanup in which the second pesticide fraction was loaded on a silica-gel minicolumn. After a Florisil minicolumn was inserted on the silica-gel minicolumn, the first pesticide fraction was loaded on the tandem minicolumn, which was eluted with acetone-petroleum ether (3 + 7). The combined eluate was subjected to dual-column gas chromatography (GC) with nitrogen-phosphorus and flame photometric detection. By application of the optimum cleanup conditions to the 52 pesticides selected, good resolution and low breakdown levels of the pesticides during GC were maintained. Recoveries of the 52 pesticides from fortified cabbage, lettuce, spring onion, and spinach ranged from 72 to 108% with relative standard deviations of 2-17%, except for the recoveries of methamidophos and chlorothalonil. The detection limits of the pesticides were satisfactory (0.001-0.009 mg/kg) for monitoring pesticide residues in vegetables.     

1H-NMR Investigation of the Binding of 2-Methylnaphthalene to α-Cyclodextrin in D2O Solutions

As -cyclodextrin (-CD) was added to D₂Osolutions of 2-methylnaphthalene, its proton signals shifted to lower fieldsat low concentrations of -CD. At 2.0 × 10^-2 moldm^-3 of -CD, however, a reverse, higher-field shift wasobserved for the H-8 signal, indicating the formation of 1 : 1 and 2 : 1-CD–2-methylnaphthalene inclusion complexes. Intrinsic chemicalshift differences of all the protons in 2-methylnaphthalene have beenevaluated for both the 1 : 1 and the 2 : 1-CD–2-methylnaphthalene inclusion complexes. These intrinsicchemical shift differences suggest that the first -CD molecule has noselectivity in accommodating one end of uncomplexed 2-methylnaphthalene;-CD binds to a methyl group, as well as a naphthalene ring-end havingno methyl group, to form the 1 : 1 inclusion complex, resulting in theformation of two kinds of 1 : 1 complexes.     

STUDIES ON HUMAN LENS: I. ORIGIN AND DEVELOPMENT OF FLUORESCENT PIGMENTS

Abstract
Fluorescence spectra of normal mature human lenses have been measured and at least eight species with distinct emission characteristics identified. To determine the specific photochemical and photophysical processes responsible for the origin and development of these fluorophores, emission behavior of the products generated by successive irradiation of young human lenses (3–6 y old) as well as of L-tryptophan solution have been systematically monitored. Fluorescent products that resulted from this irradiation were comparable to many of the fluorophores detected in aged lenses, indicating that light plays a major role in the development of these pigments. In addition to photogenerated species, there are other compounds in human lenses, presumably advanced glycosylated end products, with marked fluorescence properties.
Several oxidation products of tryptophan including N -formylkynurenine or its derivatives, β-carboline or its derivatives, and anthranilic acid have been identified in the mature human lens. The development of several photoproducts also was attributed to endogenous ascorbate-mediated Maillard reaction products, which undergo photoconversion by the visible light. Although some of these chromophores could act as photosensitaizers, the sensitizing efficiency of many are low. Conversely, the near-UV filtering capability of these colored compounds conceivably could protect the vitreous and retina from development of any photochemical lesion.     

Properties of aqueous solution of sodium glycocholate and a nonionic surfactant,and their mixtures

The micellar properties of aqueous binary mixed solutions of sodium glycocholate, NaGC, and octa-oxyethylene glycol mono-n-decyl ether, C₁₀E₈, have been studied on the basis of surface tensions, the mean aggregation number and the polarity of the interior of the micelles. The mean aggregation number, measured by steady state quenching method, decreased with the increase of the mole fraction of NaGC in the mixed system. The polarity of the interior, estimated by the ratio of first and third vibronic peak in a monomeric pyrene fluorescence emission spectrum, suggested that the hydrophobicity of intramicelles increased with the increase of the mole fraction of NaGC in the mixed system. These are considered to be caused by the differences in the chemical structure and the hydrophobic nature between NaGC and C₁₀E₈. The mean aggregation number and the polarity of the interior for each micelle near the CMC in lower total concentration of surfactants showed the tendency approaching those of pure micelle of the nonionic surfactant. This suggests that the ratio of NaGC in the initial micelles in the range of lower total concentration near the CMC is lower than that of the corresponding prepared mole fraction in the mixed system. This lower value was confirmed also from theoretical calculation of the ratio of NaGC at the CMC in the mixed micelle by regular solution treatment of Rubingh in the solution.     

Monolayer properties of mixtures of poly(n-stearyl methacrylate), poly(n-lauryl methacrylate), and their corresponding copolymers

The monolayer properties of poly(n-stearyl methacrylate), poly(n-lauryl methacrylate), and their mixtures at various ratios of the two polymers have been studied from the measurements of their surface pressure–area isotherms at air–water interface. The monolayer properties of their mixtures have been compared with those of their corresponding copolymers. The results show that the isotherms of the mixed monolayers have two break points at higher pressures than that of poly(n-lauryl methacrylate). This suggests that the mixtures may form more stable films that consist of separate phases of the two homopolymers, although each phase may contain a small amount of the other. The isotherms of the copolymer monolayers indicate a phase transition from liquid condensed to solid film between 50 segment mole % and 70% poly(n-stearyl methacrylate). The monclayer of these copolymers has properties that differ from those of the corresponding mixtures of two pure homopolymers and is more compatible than the mixtures of pure homopolymers.     

NMR Spectroscopic Observation of a Metal‐Free Acetylide Anion

A metal‐free acetylide was observed by using NMR spectroscopy. Metal‐free acetylides are closely related to reactive intermediates (carbanions) in solution; therefore, they have been regarded as unobservable species. However, we generated this highly reactive and unstable species through the deprotonation of phenylacetylene by using the strong nonmetallic phosphazene base tBu‐P4. In the presence of tBu‐P4, the J coupling between the ethynyl carbon and hydrogen nuclei (¹J_C,H) of phenylacetylene disappeared; this indicates the deprotonation of the alkyne terminal. Furthermore, a large low‐field shift (approximately 90 ppm) of the alkyne carbon resonance was observed. We concluded that we have observed a metal‐free carbanion with a formal charge on an sp‐hybridized carbon atom for the first time.     

Syndiotactic 1,2-polybutadiene with Co-CS2 catalyst system. IV. Mechanism of syndiotactic polymerization of butadiene with cobalt compounds–organoaluminum–CS2

A mechanism is proposed for the polymerization of syndiotactic 1,2-polybutadiene (s-PB) with soluble cobalt-organoaluminum-CS₂. The proposed active species have structures which consist of side-on coordination of CS₂ to cobalt, anti-π-allyl growing end, cisoid bidentate coordination of butadiene, and activation by complex formation with organoaluminum at the nonbonded sulfur of the coordinated CS₂. This proposal is based on findings for the aluminum-free catalyst Co(C₄H₆)(C₈H₁₃)-CS₂. It is tentatively interpreted that syndiotactic 1,2 polymerization proceeds under the influence of the side-on coordinated CS₂, by which the reactivity between the terminal carbons of butadiene and the C3 of the π-allyl end is enhanced.     

Homoleptic cyclometalated iridium complexes with highly efficient red phosphorescence and application to organic light-emitting diode

Phosphorescence studies of a series of facial homoleptic cyclometalated iridium(III) complexes have been carried out. The complexes studied have the general structure Ir(III)(C-N)(3), where (C-N) is a monoanionic cyclometalating ligand: 2-(5-methylthiophen-2-yl)pyridinato, 2-(thiophen-2-yl)-5-trifluoromethylpyridinato, 2,5-di(thiophen-2-yl)pyridinato, 2,5-di(5-methylthiophen-2-yl)pyridinato, 2-(benzo[b]thiophen-2-yl)pyridinato, 2-(9,9-dimethyl-9H-fluoren-2-yl)pyridinato, 1-phenylisoquinolinato, 1-(thiophen-2-yl)isoquinolinato, or 1-(9,9-dimethyl-9H-fluoren-2-yl)isoquinolinato. Luminescence properties of all the complexes at 298 K in toluene are as follows: quantum yields of phosphorescence Phi(p) = 0.08-0.29, emission peaks lambda(max) = 558-652 nm, and emission lifetimes tau = 0.74-4.7 micros. Bathochromic shifts of the Ir(thpy)(3) family [the complexes with 2-(thiophen-2-yl)pyridine derivatives] are observed by introducing appropriate substituents, e.g., methyl, trifluoromethyl, or thiophen-2-yl. However, Phi(p) of the red emissive complexes (lambda(max) > 600 nm) becomes small, caused by a significant decrease of the radiative rate constant, k(r). In contrast, the complexes with the 1-arylisoquinoline ligands are found to have marked red shifts of lambda(max) and very high Phi(p) (0.19-0.26). These complexes are found to possess dominantly (3)MLCT (metal-to-ligand charge transfer) excited states and have k(r) values approximately 1 order of magnitude larger than those of the Ir(thpy)(3) family. An organic light-emitting diode (OLED) device that uses Ir(1-phenylisoquinolinato)(3) as a phosphorescent dopant produces very high efficiency (external quantum efficiency eta(ex) = 10.3% and power efficiency 8.0 lm/W at 100 cd/m(2)) and pure-red emission with 1931 CIE (Commission Internationale de L'Eclairage) chromaticity coordinates (x = 0.68, y = 0.32).